The difference between single-component glue and two-component glue
Release time:
2024-07-31
A single component of glue is actually the main glue and auxiliary materials in line with one. In general, in the single-component glue, the thermoplastic glue is more, and the thermosetting is less. In the two-component, multi-component glue, the thermosetting is more and the thermoplasticity is less. One component of each component can be the main glue, and the other components are auxiliary materials; It can also contain both viscous materials and auxiliary materials in one component, and the other components are auxiliary materials; There can also be a group of main glue and auxiliary materials, and other components have another variety of main glue and auxiliary materials. In short, whether the composition of the glue in use is one component or multiple components depends on the interaction between the main glue and the auxiliary material selected in the glue.
Specifically, in the glue, the selection of various main glue and auxiliary materials, when any two or more materials are configured into a group, if they react or interact quickly, or they can slowly react or interact, then these materials can not be combined into a component, can only be put into two components. In fact, after the composition of the glue formula is determined, the determination of its composition mainly depends on the storage stability of the various components of the glue.
Two-component glue is the most important category of polyurethane adhesives, with wide use and large dosage. Usually composed of two components, A and B, the two components are packaged separately, and can be prepared according to a certain proportion before use.
The two-component glue is composed of a main agent containing terminated hydroxyl group and a curing agent containing terminated NCO group. Compared with a single component, the two-component glue has good performance and high bonding strength. Moreover, the ratio of two components of the same two-component polyurethane adhesive can allow a certain range, which can adjust the performance of the cured material. The main agent is usually polyurethane polyol or polymer polyester polyol. The ratio of the two components should be slightly excess of the curing agent, that is, there is a small amount of excess NCO groups, which can make up for the NCO loss caused by possible water, and ensure that the adhesive can produce enough crosslinking reaction.
Two-component glue has the following characteristics:
1: After the reactive adhesive is mixed in two components, cross-linking reaction occurs to produce curing products.
2: When preparing, the raw material composition and molecular weight of the two components can be adjusted to make it have a suitable viscosity at room temperature, and can be made into a high solid content or solvent-free two-component adhesive.
3: It can usually be cured at room temperature, and the curing speed can be adjusted by selecting raw materials for preparing adhesives or adding catalysts. In general, the two-component polyurethane adhesive has a larger initial adhesive force, called heating curing, and its final bonding strength is larger than that of the single-component adhesive, which can meet the requirements of structural adhesives.
4: The amount of two components can be adjusted within a certain range, and there is generally a certain tolerance. In general, the NCO/OH molar ratio of the two components is greater than or equal to 1. When curing, some NCO groups participate in the curing reaction of the glue, resulting in chemical adhesion. When the excess NC0 groups are heated and cured, they can also produce urea formate, biuret, etc., which increases the cross-linking degree and improves the cohesion strength and heat resistance of the adhesive layer.
Since the advent of the two-component glue, because of its adjustable performance, adhesion strength, adhesion range and other advantages, has become the largest variety of polyurethane adhesives, the largest yield of the product.
Latest News

